4/25/2023 0 Comments Weatherflow tempest![]() Values from the station and the adapter calculated (see below) values are only created when received or due for calculation. "hub_status" is updated every 10 seconds. "evt_precip" and "evt_strike" are only updated (and created) when they happen. Given sufficient battery power, "device_status" and "obs_st" data and is updated every minute, "rapid_wind" is updated every 3 seconds. There are some differences to what the Tempest-App provides, as the App gets the already processed data back from weatherflow servers. Caution: When sending data to databases for long term archiving, aliases for the states should be used to not lose the series if a unit needs replacement. States are in a tree below the hub and station ID. The adapter provides all parameters that are sent over the UDP protocol. When the debug checkbox is ticked, the adapter creates a lot of output in the log file. The adapter uses the formula the german weather service DWD is using ( nur noch hier). There may be small differences compared to the reduced pressure in the app depending on the formula used. ![]() Just use the same height as entered in the App. The station height in meters above sea level is used to calculate the reduced pressure from local pressure as is provided by the station. The listening port can be changed, which should not be required as the port the weatherstation hub is sending can not be changed, to my knowledge. The adapter provides a minimum set of setup options. Standard port the adpater listens on is 50222 but can be changed in setup. The adapter should be able to parse older stations like "Air" and "Sky" as well (but this is untested). Windows: weatherflow_udp adapter for ioBrokerĪdapter to receive and parse UDP messages from Weatherflow smart weatherstations like Weatherflow Tempest.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |